Park Heater success

mikem · Post by **mikem** » Mon Nov 14, 2011 7:36 pm

Well got a mate to plug in a scanner this morning, activated Aux heating and it works perfectly.

Timer 1 for time to come on, timer 2 for time off and sure enough on it comes and the webasto starts up with fumes from the little exhaust underneath, toasty warm too.

Bit of a releif after reading some of the epic threads on here.

malc1950 · Post by **malc1950** » Mon Nov 14, 2011 7:41 pm

Hi is your car a facelift X5

mikem · Post by **mikem** » Mon Nov 14, 2011 7:55 pm

Yes, June `06

malc1950 · Post by **malc1950** » Mon Nov 14, 2011 8:26 pm

thats good mine is a facelift 2004 , i have been told its hit and miss with a facelift, when you connected your scanner to your car and the first page came up how did you get into the aux heating settings as i have been having problems getting off the 1st page ,

mikem · Post by **mikem** » Mon Nov 14, 2011 9:02 pm

I wasn`t paying 100% attention TBH

.

It`s on the same page as the door locking speeds etc. Just clicked on Aux heating then ticked the box.

Sorry

x555 · Post by **x555** » Mon Nov 14, 2011 9:39 pm

Right malc hopefully this will help

When you first load up you will get this page (unless you have changed the settings to skip this page

)

Close this page down then run a scan and after double click on IKE

Then click on coding data

Then recoding

Then aux heater

Then IIRC click on 'write' down the bottom right hand side of the page

HTH Fella

Rusty · Post by **Rusty** » Mon Nov 14, 2011 11:52 pm

Mitch, is it possible to set the clock to GPS time or whatever it is? Just that I noticed it as an option on the same page?
Can't believe a Â£50k car needs it clock set manually.

Sent from my iPod device using Tapatalk

petert · Post by **petert** » Tue Nov 15, 2011 1:37 am

Got to agree on that last one - even a vauxhall can use the RDS time signal to keep the clock accurate and automatically change between BST/GMT...

malc1950 · Post by **malc1950** » Tue Nov 15, 2011 9:13 am

Thanks X555 i will let you know how i get on later today when i give it another go ,

malc1950 · Post by **malc1950** » Tue Nov 15, 2011 4:15 pm

Park Heater success No 2, at last my Wabasto heater is enabled and working on the OBC timers, now it wont be so bad getting into my car for work at 04.30, we also managed to alter the settings on the alarm ,job well done
thanks to X555 and all who gave me advice

dirtymonkey29 · Post by **dirtymonkey29** » Tue Nov 15, 2011 4:51 pm

Hope yours gets hot

malc1950 · Post by **malc1950** » Tue Nov 15, 2011 5:17 pm

Hi dirtymonkey i am one of the lucky ones, working fine getting hot inside the car,

dirtymonkey29 · Post by **dirtymonkey29** » Tue Nov 15, 2011 5:47 pm

Where do you live? Lol

nujon · Post by **nujon** » Tue Nov 15, 2011 7:21 pm

[quote=""mikem""]Well got a mate to plug in a scanner this morning, activated Aux heating and it works perfectly.

Timer 1 for time to come on, timer 2 for time off and sure enough on it comes and the webasto starts up with fumes from the little exhaust underneath, toasty warm too.

Bit of a releif after reading some of the epic threads on here.[/quote]

Dear Mikem

Before you enabled your heater with a scanner, did it in anycase start automatically provided the outside temp was low enough?

x555 · Post by **x555** » Tue Nov 15, 2011 8:00 pm

[quote=""malc1950""]Park Heater success No 2, at last my Wabasto heater is enabled and working on the OBC timers, now it wont be so bad getting into my car for work at 04.30, we also managed to alter the settings on the alarm ,job well done
thanks to X555 and all who gave me advice

[/quote]

glad you got it sorted

@ Sanj...this techie shit is easy

not bad for a grease monkey ehh fella's

XSeries-forum

XSeries-forum